This page was exported from Free Braindump2go Exam Dumps Camp | Free PDF and VCE
Export date: Fri Apr 19 21:17:47 2019 / +0000 GMT
2019/Jan Braindump2go 300-360 Exam Dumps with PDF and VCE New Updated Today! Following are some new 300-360 Real Exam Questions: 1.|2019 Latest 300-360 Exam Dumps (VCE & PDF) Instant Download: 2.|2019 Latest 300-360 Exam Questions & Answers Download: QUESTION 111 A. 802.3af Power over Ethernet Answer: B QUESTION 112 A. routing protocol used Answer: BEF QUESTION 113 A. Coverage Hole Detection Answer: CE QUESTION 114 A. -84 dBm Answer: C QUESTION 115 A. -65 dBm Answer: D QUESTION 116 A. NBAR2 Answer: C QUESTION 117 A. client performance metrics obtained during the survey QUESTION 118 A. Enable coverage hole detection Answer: A QUESTION 119 A. 52, 56, 60, 64 Answer: D QUESTION 120 A. Reduce the maximum threshold on the voice readiness tool to -67 dBm. QUESTION 121 A. a 5 GHz, 14-dBi patch antenna Answer: B 1.|2019 Latest 300-360 Exam Dumps (VCE & PDF) Instant Download: 2.|2019 Latest 300-360 Study Guide Video:
An engineer is determining powering requirements for a P2P wireless link using Cisco Aironet 1572EC access points.
Which power method is valid for the access point?
B. Power over Cable
C. Cisco Inline Power
D. 802.3at Power over Ethernet
17.A network engineer is performing a site survey in preparation for an installation. Which three hardware parameters must be inspected? (Choose three.)
B. PoE capability
C. switch STP capability
D. distance of antenna to communications room
E. switch port availability
F. distance of access point to communications room
An engineer has added an access point to a deployment after a post-installation site survey. The engineer then notices that there has been an increase in co-channel interference and retransmissions. Which two features can help mitigate the issue? (Choose two.)
B. Transmit Power Control
C. Enhanced Distributed Channel Access
D. Cisco Compatible Extensions
E. Dynamic Channel Assignment
You are planning the coverage for wireless VoIP by using Ekahau. Which signal strength does Ekahau recommend using for VoIP?
B. -76 dBm
C. -67 dBm
D. -53 dBm
Each vendor has their own recommended signal strength for a given data rate or application. For instance, one vendor may recommend designing their VoIP solution at -67 dBm (perhaps the most widely-used value for VoIP deployment if I had to choose one), while another may say -70 dBm. In most cases the values will differ only by a couple dB.
You must upgrade a data-based wireless network to support Voice over Wireless. Which RSSI measurement do you use to redesign the wireless network?
B. -72 dBm
C. -75 dBm
D. -67 dBm
You must create a simple implementation of QoS on a WIAN. The implementation must allow clients to prioritize traffic into these four classes:
- best effort
Which option do you enable?
B. NetFlow v9
D. Cisco AVC
WMM uses the 802.1P classification scheme (part of the IEEE 802.1D MAC Bridges standard). This classification scheme has eight priorities that WMM maps to four access categories with WMM designations:
A post-deployment active wireless site survey was just completed for a company. Which two pieces of information must be included in the site survey report? (Choose two.)
B. heat maps from the data that was captured
C. floor plans for Cisco Prime Infrastructure
D. existing WLC configurations
E. RRM recommendations for the WLC
An engineer wants the controller to report when a client exceeds the minimum acceptable RSSI level, to ensure support for the minimum data rate required.
Which controller option must be configured?
B. Enable the coverage optional mode.
C. Set the DCA channel sensitivity to high.
D. Set the coverage exception level per AP to 0.
If clients on a lightweight access point are detected at threshold levels (RSSI, failed client count, percentage of failed packets, and number of failed packets) lower than those specified in the RRM configuration, the access point sends a "coverage hole" alert to the controller. The alert indicates the existence of an area where clients are continually experiencing poor signal coverage, without having a viable access point to which to roam. The controller discriminates between coverage holes that can and cannot be corrected. For coverage holes that can be corrected, the controller mitigates the coverage hole by increasing the transmit power level for that specific access point. The controller does not mitigate coverage holes caused by clients that are unable to increase their transmit power or are statically set to a power level because increasing their downstream transmit power might increase interference in the https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-0/configuration/guide/c70/c70rrm.html
During an installation of a wireless network in a country that follows ETSI standards, the customer is requesting to manually set the channels on the 2.4GHz radios.
Which channels are recommended for use in this deployment?
B. 1, 6, 11, 14
C. 36, 40, 44, 48
D. 1, 5, 9, 13
A customer wants to upgrade their current wireless infrastructure to support wireless voice capabilities. When using a voice readiness assessment tool, the customer notes that multiple areas have failed to meet the requirements
How should the customer resolve this issue?
B. Perform a site survey to position access points in the facility?
C. Ensure that there is a 1 to 5 ratio of monitor mode to local mode access points
D. Increase the power on all the access points to 25mW or more.
You are designing an outdoor mesh network to cover several sports fields. The core of the network is located in a building at the entrance of a sports complex.
Which type of antenna do you use with the RAP for backhaul connectivity?
B. a 5 GHz, 8-dBi omnidirectional antenna
C. a 2.4 GHz, 14-dBi omnidirectional antenna
D. a 2.4 GHz, 8-dBi patch antenna
The AP1524PS includes three radios: a 2.4-GHz, a 5.8-GHz, and a 4.9-GHz radio. The 2.4-GHz radio is for client access (non-public safety traffic) and the 4.9-GHz radio is for public safety client access traffic only. The 5.8-GHz radio can be used as the backhaul for both public safety and non-public safety traffic.
2019/Jan Braindump2go 300-360 Exam Dumps with PDF and VCE New Updated Today! Following are some new 300-360 Real Exam Questions:
1.|2019 Latest 300-360 Exam Dumps (VCE & PDF) Instant Download:
2.|2019 Latest 300-360 Exam Questions & Answers Download:
A. 802.3af Power over Ethernet
A. routing protocol used
A. Coverage Hole Detection
A. -84 dBm
A. -65 dBm
A. client performance metrics obtained during the survey
A. Enable coverage hole detection
A. 52, 56, 60, 64
A. Reduce the maximum threshold on the voice readiness tool to -67 dBm.
A. a 5 GHz, 14-dBi patch antenna
1.|2019 Latest 300-360 Exam Dumps (VCE & PDF) Instant Download:
2.|2019 Latest 300-360 Study Guide Video:YouTube Video: YouTube.com/watch?v=TbRAeeZLA7E
YouTube Video: YouTube.com/watch?v=TbRAeeZLA7E
Post date: 2019-01-31 07:37:04
Post date GMT: 2019-01-31 07:37:04
Post modified date: 2019-01-31 07:37:04
Post modified date GMT: 2019-01-31 07:37:04
Powered by [ Universal Post Manager ] plugin. MS Word saving format developed by gVectors Team www.gVectors.com